xfrm: fix "disable_policy" flag use when arriving from different devices
In IPv4 setting the "disable_policy" flag on a device means no policy
should be enforced for traffic originating from the device. This was
implemented by seting the DST_NOPOLICY flag in the dst based on the
originating device.
However, dsts are cached in nexthops regardless of the originating
devices, in which case, the DST_NOPOLICY flag value may be incorrect.
Consider the following setup:
+------------------------------+
| ROUTER |
+-------------+ | +-----------------+ |
| ipsec src |----|-|ipsec0 | |
+-------------+ | |disable_policy=0 | +----+ |
| +-----------------+ |eth1|-|-----
+-------------+ | +-----------------+ +----+ |
| noipsec src |----|-|eth0 | |
+-------------+ | |disable_policy=1 | |
| +-----------------+ |
+------------------------------+
Where ROUTER has a default route towards eth1.
dst entries for traffic arriving from eth0 would have DST_NOPOLICY
and would be cached and therefore can be reused by traffic originating
from ipsec0, skipping policy check.
Fix by setting a IPSKB_NOPOLICY flag in IPCB and observing it instead
of the DST in IN/FWD IPv4 policy checks.
Fixes: 1da177e4c3f4 ("Linux-2.6.12-rc2")
Reported-by: Shmulik Ladkani <[email protected]>
Signed-off-by: Eyal Birger <[email protected]>
Signed-off-by: Steffen Klassert <[email protected]>
diff --git a/include/net/ip.h b/include/net/ip.h
index 3984f2c..0161137 100644
--- a/include/net/ip.h
+++ b/include/net/ip.h
@@ -56,6 +56,7 @@ struct inet_skb_parm {
#define IPSKB_DOREDIRECT BIT(5)
#define IPSKB_FRAG_PMTU BIT(6)
#define IPSKB_L3SLAVE BIT(7)
+#define IPSKB_NOPOLICY BIT(8)
u16 frag_max_size;
};
