LSM6DSV16XTR STM32 硬件spi驱动

gongyuan073

已于 2025-01-14 17:43:56 修改

阅读量550

点赞数 3

CC 4.0 BY-SA版权

文章标签： stm32 嵌入式硬件单片机

于 2025-01-14 17:43:07 首次发布

本文链接：https://blog.csdn.net/gongyuan073/article/details/145144443

在使用LSM6DSV16XTR时硬件i2c接口被占用,不想要共用其他设备所以就把芯片的接口从i2c改为spi接口。硬件接线如下：

spi配置如下：

在驱动代码中做如下更改：

int32_t platform_write(void *handle, uint8_t reg, const uint8_t *bufp, uint16_t len)
{
	uint8_t address = reg & 0x7F;
//  HAL_I2C_Mem_Write(handle, LSM6DSV16X_I2C_ADD_L, reg, I2C_MEMADD_SIZE_8BIT, (uint8_t*) bufp, len, 0xFF);
	HAL_GPIO_WritePin(GYRO_CS_GPIO_Port,  GYRO_CS_Pin, GPIO_PIN_RESET);

	HAL_SPI_Transmit(handle, &address, 1, 0xffff);
	HAL_SPI_Transmit(handle, bufp, len, 0xffff);

	HAL_GPIO_WritePin(GYRO_CS_GPIO_Port,  GYRO_CS_Pin, GPIO_PIN_SET);
	
  return 0;
}


int32_t platform_read(void *handle, uint8_t reg, uint8_t *bufp, uint16_t len)
{
	uint8_t address = reg | 0x80;
//  HAL_I2C_Mem_Read(handle, LSM6DSV16X_I2C_ADD_L, reg, I2C_MEMADD_SIZE_8BIT, bufp, len, 0xFF);
	HAL_GPIO_WritePin(GYRO_CS_GPIO_Port,  GYRO_CS_Pin, GPIO_PIN_RESET);

	HAL_SPI_Transmit(handle, &address, 1, 0xffff);
	
	HAL_SPI_Receive(handle, bufp, len, 0xffff);

	HAL_GPIO_WritePin(GYRO_CS_GPIO_Port,  GYRO_CS_Pin, GPIO_PIN_SET);
	
  return 0;
}

测试ID读取成功。