ESP32学习笔记08-adc单通道数据采集

static void check_efuse(void) { #if CONFIG_IDF_TARGET_ESP32 //Check if TP is burned into eFuse if (esp_adc_cal_check_efuse(ESP_ADC_CAL_VAL_EFUSE_TP) == ESP_OK) { printf("eFuse Two Point: Supported\n"); } else { printf("eFuse Two Point: NOT supported\n"); } //Check Vref is burned into eFuse if (esp_adc_cal_check_efuse(ESP_ADC_CAL_VAL_EFUSE_VREF) == ESP_OK) { printf("eFuse Vref: Supported\n"); } else { printf("eFuse Vref: NOT supported\n"); } #elif CONFIG_IDF_TARGET_ESP32S2 if (esp_adc_cal_check_efuse(ESP_ADC_CAL_VAL_EFUSE_TP) == ESP_OK) { printf("eFuse Two Point: Supported\n"); } else { printf("Cannot retrieve eFuse Two Point calibration values. Default calibration values will be used.\n"); } #else #error "This example is configured for ESP32/ESP32S2." #endif } static void print_char_val_type(esp_adc_cal_value_t val_type) { if (val_type == ESP_ADC_CAL_VAL_EFUSE_TP) { printf("Characterized using Two Point Value\n"); } else if (val_type == ESP_ADC_CAL_VAL_EFUSE_VREF) { printf("Characterized using eFuse Vref\n"); } else { printf("Characterized using Default Vref\n"); } } void app_main(void) { //Check if Two Point or Vref are burned into eFuse check_efuse(); //Configure ADC if (unit == ADC_UNIT_1) { adc1_config_width(width); adc1_config_channel_atten(channel, atten); } else { adc2_config_channel_atten((adc2_channel_t)channel, atten); } //Characterize ADC adc_chars = calloc(1, sizeof(esp_adc_cal_characteristics_t)); esp_adc_cal_value_t val_type = esp_adc_cal_characterize(unit, atten, width, DEFAULT_VREF, adc_chars); print_char_val_type(val_type); //Continuously sample ADC1 while (1) { uint32_t adc_reading = 0; //Multisampling for (int i = 0; i < NO_OF_SAMPLES; i++) { if (unit == ADC_UNIT_1) { adc_reading += adc1_get_raw((adc1_channel_t)channel); } else { int raw; adc2_get_raw((adc2_channel_t)channel, width, &raw); adc_reading += raw; } } adc_reading /= NO_OF_SAMPLES; //Convert adc_reading to voltage in mV uint32_t voltage = esp_adc_cal_raw_to_voltage(adc_reading, adc_chars); printf("Raw: %d\tVoltage: %dmV\n", adc_reading, voltage); vTaskDelay(pdMS_TO_TICKS(1000)); } }