Process water
| Process water covers the wide range of boiler feed water, cooling water for heat exchangers or engine, chemicals dilution, etc... It should typically have a conductivity ranging from 0,1 to 50 uS/cm, with little to no hardness to avoid scaling in heating system. Oxygen and carbon dioxide should be removed to prevent corrosion Depending on your application, the water quality requirements can vary: Boiler feed water characteristic Tap water or fresh groundwater are the most widely used source of water to produce process water. Our process water treatment plant can combine various technology, depending on the purity required:
Once demineralised, process water should be conditionned according to manufacturer's specification, usually up to pH 9 by adding caustic soda or ammonia. More information on demineralised water Further demineralisation is also possible to obtain ultra-pure water quality Boiler Make-up Water |
Lenntech (European Head Office)
Distributieweg 3
2645 EG Delfgauw
The Netherlands
Phone: +31 152 610 900
fax: +31 152 616 289
e-mail: [email protected]
Lenntech USA LLC (Ameryki)
5975 Sunset Drive
South Miami, FL 33143
USA
Phone: +1 877 453 8095
e-mail: [email protected]
Lenntech DMCC (Bliski Wschód)
Level 6 - OFFICE #101-One JLT Tower
Jumeirah Lake Towers
Dubai - U.A.E.
Phone: +971 4 429 5853
e-mail: [email protected]
Copyright © 1998-2025 Lenntech B.V. All rights reserved