Scribd
Upload
289 views1 page

ASME Sec.VIII Div.1 Design Guide

Uploaded by

Chetan Sheth
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
289 views1 page

ASME Sec.VIII Div.1 Design Guide

Uploaded by

Chetan Sheth
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ASME Sec.VIII Div.

1 Cheat Sheet
Design

Internal Pressure External Pressure – Cylindrical shell


1. Assume thickness “t”
2. Calculate L/Do and Do/t
3. Determine Factor “A”
4. Go to Material chart
5. Determine Factor “B”

Maximum Allowable External Pressure =


4𝐵
3 𝐷𝑜/𝑡

Minimum Nozzle Neck Thickness


Nozzle Reinforcement
✓ Area Removed ≤ Area Available + Area Reinforced

Forming Strain, Hydro Test,


if Strain >=5 % Stress relieving Heat treatment to be ✓ 1.3*LSR*(Design Pressure or MAWP)
done ✓ Or 1.3*MAP

Pneumatic Test,
✓ Normally, not performed. To be done in
special case only.
✓ 1.1*MAWP*LSR

Different Stress and Allowable limit,


Stamping of Vessel ✓ Pm ≤ S
✓ Pm + Pb ≤ 1.5*S
Specific Marking
✓ Pm + Pb + Q ≤ 3*S
▪ “RT-1,2,3,4”
▪ “HT” or “PHT” Permissible Out-of-Roundness,
✓ 1 % of Nominal Diameter
✓ 2 % @ opening
Terms: MAWP = Maximum allowable working Pressure, MAP = Maximum Allowable Pressure, LSR = Lowest Stress ratio
Created by : Vishal Tailor
Pm = Primary membrane, Pb = Primary Bending, Q= Secondary, S = Allowable stress Gujarat-INDIA

You might also like