INSTITUTE OF COMPREHENSIVE EDUCATION (I.C.E.
)
GUSAU, ZAMFARA STATE
SUBJECT: BASIC TECHNOLOGY 7. Which instrument is used to measure the resistance of a
CLASS: JSS III resistor? (a) ohmmeter (b) resistmeter (c) wattmeter (d)
TIME ALLOWED: 2HRS meter
8. Maintenance which includes replacement of some parts in a
SECTION A: OBJECTIVES
machine is called ______ maintenance (a) preventive (b)
ANSWER ALL QUESTIONS corrective (c) predictive (d) none of the above
1. An electric motor converts ______? (a) mechanical energy to 9. Metals can basically be divided into? (a) Material and non-
material (b) natural and synthetic (c) Ferrous and non-
electrical (b) electrical energy to chemical (c) electrical energy
ferrous (d) Metal and non-Metal
to mechanical (d) mechanical energy to heat 10.If voltage of 20 volts is applied to a circuit of 4ohms resistance,
2. E.M.F. stands for ___ ? (a) Electro-Magnetic Force (b) Electro- what is the amount of current flow? (a) 4 ohms (b) 5
Micro Force (c) Electro-Muscular Force (d) Electro-Motive volts (c) 6 amps (d) 5 amps
Force 11.Right angles are always _____ (a) 90o (b) 60o (c) 180o (d) 30o
3. The Standard unit of measuring current is __ (a) amperes (b)
12.A radius of a circle is _______ (a) half of a circle (b) half of a
ohms (c) metres (d) volts
diameter (c) an angle in a circle (d) twice a diameter
4. The input of a transformer is at _______ (a) secondary winding
13.In Nigeria, Electrical power is transmitted at which frequency?
(b) primary winding (c) central winding (d) output (a) 60Hz (b) 80Hz (c) 50Hz (d) 100Hz
winding 14.In Nigeria, the line voltage is (a) 200volts (b) 220volts (c)
5. In an orthographic projection, hidden edges are represented by 500volts (d) 400volts
___ lines. (a) straight (b) vertical (c) broken (d) 15.If two resistors of the same value of 2 ohms each are connected
horizontal in parallel, find the total resistance of the resistors. (a) 1
6. Which of the following is the mathematical representation of ohms (b) ½ ohm (c) 4 amps (d) 1 amps
W V P V
OHM’s LAW? (a) I = (b) P = (c) R = (d) I = 16.If 3 resistors; 6 ohms, 8 ohms and 2 ohms are connected in
R R I R
series, what is the total resistance of the resistors? (a) 16
volts (b) 16 ohms (c) 16 amps (d) 16 watts
End Of Second Term Examination 2019/2020 Session
17.If a bulb of 100 watts is connected to a battery of 25 volts, SECTION B
calculate the amount of current flowing in the circuit. (a) 6
Answer any Four (4) Questions from this section
amps (b) 5 amps (c) 4 amps (d) 4 volts
18.Poor conducting materials always have ________ (a) no 1. a. State OHM’s law.
resistance (b) free resistance (c) low resistance (d) high b. Define the following:
resistance (i) Current (ii) Voltage (iii) Resistance (iv) Electrical power
19.An electrical transformer can only be operated through (a) A.C 2. a. A bulb of 4 ohms resistance is connected to 220 volts.
voltage (b) D.C voltage (c) Cells voltage (d) none of the Calculate the current that will flow in the circuit.
above b. A circuit of 16 ohms resistor allows current flow of 120
20.The region between two radii is called? (a) chord (b) amps. Calculate the voltage applied.
sector (c) segment (d) arc 3. Three resistors; 4, 6, and 10 ohms are connected in a series
circuit. The circuit is connected to a battery of 100 volts.
Calculate:
(i) The total resistance of the circuit
(ii) The total circuit current
(iii) The voltage across the each resistor
4. If a circuit has two (2) resistors 2 and 4 ohms connected in
parallel and the current flow is 4 amps. Calculate:
(i) The total resistance of the circuit
(ii) The voltage applied
(iii) The current in each resistor
5. a. Calculate the electrical power of a bulb if it allows 6 amps
current flow when voltage applied is 20 volts
b. Calculate the electrical power when the current flow is 6
amps through a resistor of 5 ohms.
End Of Second Term Examination 2019/2020 Session
