WIND ENERGY

presentation
Submitted by,
1.{GROUP LEADER} MIRZA ALTAMAS MIRZA NOOR AZAM. {100}
2. ANSARI FARHAN MOHD SIIDIQUE. {119}
3.SHAIKH SHAFIK SULTAN. {114}

IN A PARTIAL FULFLIMENT FOR THE AWORD OF THE DIGREE OF

DIPLOMA IN MECHANICAL ENGG DEPT.

UNDER THE GUIDANCE OF

MR.SAJID DESHMUKH (LECTURER
MECH ENGG DEPT.)
 HOW IT WORKS

Wind is a form of Solar energy

Wind is caused by the uneven heating of

the earth’s surface and rotation of the Earth

Wind Turbines convert the kinetic energy in the wind to

mechanical power

A generator can convert the mechanical power into electricity

 How it works cont.
 A wind turbine works the opposite of a fan

 The wind turns the blades, which spin a shaft,

 Which connects to a generator and makes
electricity.
 The Parts
 Anemometer
 -measures the wind speed
 Blades
 -most turbines have 2 or 3. Wind blowing
 over the blades causes the blades to lift and
 rotate

 Brake
 -A disc brake can be used to stop the
 rotor in emergencies
 The Parts
 Controller
 -The controller starts up the machine at wind
speeds of about 8 to 16 miles per hour (mph)
and shuts off the machine at about 55 mph.
Turbines do not operate at wind speeds above
about 55 mph because they might be damaged
by the high winds.
 Gear box
 Gears connect the low-speed shaft to the high-
speed shaft and increase the rotational speeds
from about 30 to 60 rotations per minute (rpm)
to about 1000 to 1800 rpm, the rotational speed
required by most generators to produce
electricity. The gear box is a costly (and heavy)
part of the wind turbine and engineers are
exploring "direct-drive" generators that operate
at lower rotational speeds and don't need gear

boxes.
 The Parts
 Generator
 -Usually an off-the-shelf induction generator
that produces 60-cycle AC electricity. Gear box

 Low-speed shaft
 -The rotor turns the low-speed shaft at about
30 to 60 rotations per minute.

 Nacelle
 -The nacelle sits atop the tower and
contains the gear box, low- and high-
speed shafts, generator, controller, and
brake. Some nacelles are large enough
for a helicopter to land on.
 The Parts
 Pitch
 -Blades are turned, or pitched, out of the wind
to control the rotor speed and keep the rotor
from turning in winds that are too high or too
low to produce electricity.
 Rotor
 -The blades and the hub together are called the
rotor.
 Tower
 -Towers are made from tubular steel (shown
here), concrete, or steel lattice. Because wind
speed increases with height, taller towers
enable turbines to capture more energy and
generate more electricity.

.
 The Parts
 Wind direction
 This is an "upwind" turbine, so-called because it
operates facing into the wind. Other turbines are
designed to run "downwind," facing away from
the wind

 Wind vane:
 Measures wind direction and communicates
with the yaw drive to orient the turbine properly
with respect to the wind.

 Yaw drive:
 Upwind turbines face into the wind; the yaw
drive is used to keep the rotor facing into the
wind as the wind direction changes. Downwind
turbines don't require a yaw drive, the wind
blows the rotor downwind.

 Yaw motor:
 Powers the yaw drive.
 Where Wind is Headed
 Developments and
investments in wind
energy
 High Altitude Wind
– Hotspots 4 miles
high
 D.I.Y. Wind Power
 Investment -
Throwing Money into the Wind
 The British Wind
Energy Association
predicts wind to
overtake nuclear in
U.K. in the next www.finfacts.com

decade.
 9 GW of electricity
from offshore wind
farms by 2015 in
U.K.
 Investment – cont.

 China expects wind output to exceed nuclear by 2020.

 Currently has 12 GW of capacity. Plans to increase
capacity by 20% per year.
 Has targeted goal of 100 GW from wind by 2020.
  In 2008, a 27 GW increase in wind capacity was
achieved moving total global wind capacity above
120 GW.

 U.S. and China account for over 50% of 2008 growth

with additional 8 GW and 6 GW of new capacity.
 www.eia.doe.gov

Electricity generated from wind has

increased from 0.1% in 1997 to
1.5% in 2008.

www.eia.doe.gov
High Altitude Wind Power
 Why High Altitude
The amount of power a  Each hemisphere has
wind turbine can 2 jet streams –
generate is expressed the polar jet stream
by the function: and the sub-tropical
Wind Power Density = jet stream
½ pV3 The jet streams
p = wind density provide consistent,
V = wind speed strong and abundant
winds
(The wind blows faster =
more power even Energy available in
though air is less the jet stream is
dense higher up) roughly 100 times the
global demand
 Making High Altitude Wind into Sea
Level Energy
 Flying Electric  Kite Generators
Generators
 Flying Electric Generators
 Designed to be High
Altitude ~ 6 miles
closer to the jet stream
 2 to 4 rotors, used for
both lift and power
generation, mounted
to a lightweight
airframe
 Would need to be
tethered to ground for
power collection and
control.
Kite Generators - Part 1
 Power is generated
as the kite is pulled
and released.
 Tethered to a
ground based
generator.
 Additional power
can be obtained by
capturing the
rotational forces of
the kite as well
 Kite Generators – Part 2
 Again, kites are
tethered to a land
based generator,
pulled and released
resulting in energy
gain.
 Rotational energy is
captured by carousel
turned by kites.
 Kite generators are
designed to operate
about ½ mile high.
 High Altitude Hot Spots
 Using wind data from
1979 – 2006, wind
hotspots have been
found ~ 6 miles high
over Tokyo, Seoul, New
York City and Sydney
 To date, there has been
no long term testing or
prototype to provide
information on cost
and/or power
generated.
 Sky Windpower Corp.
and KiteGen are
developing the
technologies.

X = Wind Power Density (kW/m2) (0-20)

Y= Elevation in km above ground (0-12)
 Fun With Wind
D.I.Y.
Links to design, plan and build
your own wind generator. Hugh Piggiott
has compiled an extraordinary amount
of useful information if you plan to build your
own wind generator.

William Kamkwamba –
built his family a wind
generator from old
bicycles and other
spare parts at the age
of 15.