Chapter_2.pptx .

Department of Physics - MIT, Manipal 1
Chapter 2
DIFFRACTION PATTERNS AND
POLARIZATION
OBJECTIVES
• To understand the principles of diffraction.
• To explain the intensity distribution in diffraction under
various conditions.
• To explain the diffraction of light waves at single, multiple slits
and circular apertures.
• To understand polarization phenomena and various
techniques used to produce polarized light.

Introduction to Diffraction Patterns
Light of wavelength comparable to or larger than the width of a slit spreads out in all
forward directions upon passing through the slit. This phenomenon is called diffraction
(a) The diffraction pattern that
appears on a screen when
light passes through a narrow
vertical slit.
(b) Diffraction pattern created by
the illumination of a penny, with the
penny positioned midway between
the screen and light source.

Diffraction Patterns from Narrow Slits
• Here we assume the observing
screen is far from the slit and the
rays reaching the screen are
approximately parallel.
• In laboratory, this situation can
also be achieved experimentally
by using a converging lens to
focus the parallel rays on a nearby
screen.
• In this model, the pattern on the
screen is called a Fraunhofer
diffraction pattern.

• To analyze the diffraction pattern, let’s divide the slit
into two halves as shown in Figure.
• If this path difference is exactly half a wavelength
(corresponding to a phase difference of 180°), the pairs
of waves cancel each other and destructive interference
results.
• Ray 1 and Ray 3 are out of phase by 180°
• Similarly Ray 2 and Ray 4 are out of phase by 180°
• Hence we can write
𝑎
2
sin  = ±

2
• Dividing the slit into four equal parts and using similar reasoning, we find that the
viewing screen is also dark when sin  = ± 2

𝑎
• Therefore, the general condition for destructive interference is
...
,
3
,
2
,
1
m
a
m
sin 




dark



Intensity of Single-Slit Diffraction Patterns
 
2
max
sin sin /
sin /
a
I I
a
  
  
 
  
 
Analysis of the intensity variation in a diffraction pattern from a single slit of width ‘a’
shows that the intensity is given by
where Imax is the intensity at  = 0 (the
central maximum) and  is the
wavelength of light used to illuminate
the slit.

Intensity of Two-Slit Diffraction Patterns
 
2
2
max
sin sin /
sin
cos
sin /
a
d
I I
a
  
 
   
 
 
  
 
   
When more than one slit is present, we must consider not only diffraction patterns due
to the individual slits but also the interference patterns due to the waves coming from
different slits. Intensity due to combined effect is given by
Above equation represents the single-slit
diffraction pattern (the factor in square
brackets) acting as an “envelope” for a two
slit interference pattern (the cosine-squared
factor).
If
𝑑
𝑎
= 𝑚 where m is an interger
In this case, mth interference maximum
coincides with first diffraction minimum.

Resolution of Single-Slit and Circular Apertures
The ability of optical systems to distinguish between closely spaced objects is limited
because of the wave nature of light.
When the central maximum of one image falls on the first minimum of another
image, the images are said to be just resolved. This limiting condition of resolution is
known as Rayleigh’s criterion.
In case of single-slit diffraction pattern, this
occurs at the angle for which
sin  =

𝑎
Since  << a
𝑚𝑖𝑛 =

𝑎

Circular Aperture: Analysis shows that the limiting angle of resolution of the
circular aperture is
𝑚𝑖𝑛 = 1.22

𝐷
where D is the diameter of the aperture.

Diffraction Grating
• A transmission grating can be made by cutting parallel grooves on a glass plate with a
precision ruling machine. The spaces between the grooves are transparent to the
light and hence act as separate slits.
• A reflection grating can be made by cutting parallel grooves on the surface of a
reflective material.
...
,
3
,
2
,
1
,
0
m
m
sin
d 




bright 


Diffraction of X-Rays by Crystals
• Crystal acts as 3D grating for X-rays.
• Condition for constructive interference (maxima
in the reflected beam) is
...
,
3
,
2
,
1
m
m
sin
d
2 
 

This condition is known as Bragg’s law

Polarization of Light Waves
Schematic diagram of an
electromagnetic wave propagating
at velocity c in the x direction. The
electric field vibrates in the xy
plane, and the magnetic field
vibrates in the xz plane.
(a) A representation of an unpolarized
light beam viewed along the direction of
propagation. The transverse electric field
can vibrate in any direction in the plane of
the page with equal probability. (b) A
linearly polarized light beam with the
electric field vibrating in the vertical
direction.

Polarization by Selective Absorption
2
max cos
I I 

Polaroid is a device which polarizes
unpolarized light when light passes
through it.
Malus’s law
The component of 𝑬𝟎 parallel to
the analyzer axis, which is
transmitted through the analyzer, is
E0 cos .
Intensity is square of magnitude of
field vector. Hence,
Two polarizing sheets whose transmission
axes make an angle u with each other. Only
a fraction of the polarized light incident on
the analyzer is transmitted through it.

Polarization by Reflection
𝑛2
𝑛1
=
sin 𝑝
sin 2
But, 2 = 90 - p. So, we can write,
tan 𝑝 =
𝑛2
𝑛1
This expression is called Brewster’s
law, and the polarizing angle p is
sometimes called Brewster’s angle
For one particular angle of incidence
(p), the reflected light is completely
polarized.
Using Snell’s law of refraction

Polarization by Double Refraction
Unpolarized light incident at an angle to the
optic axis in a calcite crystal splits into an
ordinary (O) ray and an extraordinary (E)
ray
The pattern is produced when the
plastic model is viewed between a
polarizer and analyzer oriented
perpendicular to each other. Such
patterns are useful in the optimal
design of architectural components

Polarization by Scattering
The scattering of unpolarized sunlight by air
molecules.
Optical Activity
• A material is said to be optically active if it rotates the plane of polarization of any
light transmitted through the material.
• The angle through which the light is rotated by a specific material depends on the
length of the path through the material and on concentration if the material is in
solution.

Chapter_2.pptx .

More Related Content

Similar to Chapter_2.pptx . (20)

More from happycocoman (20)

Recently uploaded (20)

Chapter_2.pptx .