clinicalpathologyppt-220319134410.pptx

COLLECTION, TRANSPORTATION, PREPARATION,
PROCESSING, AND STORAGE OF LABORATORY SAMPLES
FOR THE DIAGNOSIS AND MONITORING OF DISEASES
A SEMINAR PREPARED
BY
LAWAL, BELLO DANCHADI
ADM NO: 22210705001
DEPARTMENT OF CHEMICAL PATHOLOGY AND
IMMUNOLOGY
USMANU DANFODIYO UNIVERSITY, SOKOTO

SAMPLE COLLECTION
BLOOD collection method
> Blood collection, or the collection ofblood, usually involves the removal ofblood and it comes in many different
forms. It's also a common term in blood sampling for laboratory analysis.
> Three popular methods ofblood collection are:
1. Arterial Sampling
2. Venipuncture Sampling
3. Fingerstick Sampling

1.ARTERIAL SAMPLING
> This form ofblood collection most commonly takes place within a
hospital environment.
> It is used in the identification ofmetabolic, respiratory, and mixed
acid-base disorders, where CO2 levels require understanding or
monitoring.
> While generally safe, the procedure can be upsetting and painful for
the patient.
> There are also several potential contradictions that can affect the
site of the collection, such as an abnormal modified Allen test or
local infection.
> There is also an increased risk ofbleeding complications inpatients
with coagulopathy.

2. VEINPUNCTURE SAMPLING
> Venipuncture is the most common way to collect blood from adult patients.
> Collection takes place from a superficial vein in the upper limb, generally
the median cubital vein; this vein is close to the skin and doesn’thave many
large nerves positioned close by.
> This reducespain and discomfort for the patient.
> Clean the sight with spirit allow to dry. Readily attached shyring and needle
is introduced to the vein with the level facing upward at an angle of 30 – 40
* to the skin.
> Entrance into the vein is denoted by appearance ofblood into the hub of the
needle.
> Release the tourniquet an withdrawn the needle . The blod is transfer into the
appropriate containers.

3. FINGERSTICK SAMPLING
> Fingerstick or finger prick sampling involves taking a very small amount of
blood from the patient, usually from the end of a finger.
> It is also known asCapilary blood collection.
> It is over quickly and requires very little in the way ofpreparation;
therefore, reducing concern and anxiety inpatients, particularly in children and
nervous adults.
> Clean the finger with alcohol swab and allow to dry.
> Hold the ball finger and make a quick puncture about ½ cm from the end
using a sterile lancet, wipe the first drop as it may contains tisuue fluids.
> The blood should floe freely, without applying pressure collect the
succeeding drop for investigation.
> It is mainly used for doing differential count, cell count, Hb estimation , etc
…

 Before or after the sample collection the tube should be labelled immediately.
 Requiring patients to state their full name and birthdate, and to spell their first name
and lastname;
 Requiring outpatients to show a form of identification when an ID band is not in
use, typically a driver’s license or insurance card;
 >Labeling specimen tubes in the presence ofthe patient after the draw;
 Visually comparing tube labels with the ID band or requiring the patient to
confirm samples are properly labeled.
 t should be help avoid errors.
LABELLING

TYPES OF BLOOD COLLECTION TUBES
Red :
> No anticoagulant or additives.
> Collection of serum for chemical or serological and bacteriologic studies.
> Maybe used for any procedure requiring serum except HLA antibody tests.
Lavender :
> Contains EDTA (Ethylene Diamine Tetra Acetate) as the anticoagulant.
> Mix well Primarily for collection of hematology studies, blood bank procedures and certain chemistries.
Blue :
> Contains sodium citrate (0.109M, 3.2%) solution as the anticoagulant.
> Primarily for collection of coagulation studies.
Gray :
> Contains potassium oxalate and sodium fluoride as the anticoagulant.
> Mix well For the collection of glucose and lactate samples.
> Not suitable for enzymes or electrolytes.

Green :
> Contains lithium heparin as the anticoagulant.
> Mix well For collection of other miscellaneous studies.
> Electrolytes, glucose, BUN can be performed more quickly than from a red top.
Special green :
> Sterile, contains sodium heparin as the anticoagulant.
> For collection of flow cytometry specimens.
Yellow :
> contains ACD (Acid Citrate Dextrose) as the anticoagulant.
> For determination of HLA-ABC antigens, HLA-B27, HLA Molecular Typing, G6PD levels and
acid phosphatase levels.
Pink :
> Does not contain any anticoagulant, serum separator, or silicone coating.
> For detection of HLA antibodies in serum (CYTS).

URINE SAMPLE COLLECTION METHOD
What is urine ?
> Urine is an ultrafiltrate of the blood plasma and fluid created in the kidney and stored in the
urinary bladder.
> It is a waste product and it can give usa wealth of information! Many metabolic diseases can be
detected and monitored via the urine.
> Urine is mostly water with dissolved metabolites.
Urine Specimen Types Include:
First Morning Urine:
> very first urine voided when waking up after sleep, since it has been retained and incubating in
the bladder for 6-8 hours and is the most concentrated specimen
• ideal for testing for protein or to confirm postural or orthostatic proteinuria
• ideal for testing for nitrites
• red blood cells, white blood cells, and casts that maybe present will be more stable.
• The urine is slightly more acidic and has high osmolality
during the night before, the individual should void right before going to bed

Random Urine Specimen:
> This type ofurine specimen can be collected at anytime, whether day or night
> No prior patient preparation
> Easy and convenient
> Good for routine screening
> Good for cytology studies
> Good for fluid deprivation studies
> “Random clean catch" type of specimens can also be performed after good hydration and are
perfect for cytology studies
> Individual will consume 24-32 oz ofwater each hour for 2 hours prior to urine collection may
require collection daily for 3-5 consecutive days
> Enhanced by patient exercise for 5 minutes prior to specimen collection (jumping, skipping,
running in place)

Timed Collection:
> This specimen is collected throughout a very specific time interval (ex: 2 hours, 12 hours, 24 hours,
over a weekend, etc...)
> Avoid at the beginning of the collection then discard it
> Collect all subsequent urines
> Include the last void in the urine
Catheterized Urine:
> Obtained using a sterile, flexible tube catheter, which is inserted into the urethra and into the bladder
> Urine flows into the bladder by gravity and is collected in a plastic reservoir bag
> Requires healthcare personnel to perform
> UTIs are common in catheterized patients, so these are often sent for bacterial culture

Catheterized Urine sample collection

Routine Void:
> Does not require patient preparation
> Simple urination into a specimen collection container
Midstream "Clean Catch:
> Urine is collected after thorough cleansing ofthe urethral opening with antiseptic wipes
> The individual must pass the first portion of the urine in the toilet, stop the stream, then collect the mid
portion of the urine into the specimen container, followed bypassing remaining urine into the toilet
> Ideal for the routine urinalysis and urine culture free from contamination
Suprapubic Aspiration:
> A rare technique used to collect urine directly form the bladder via the puncturing of the abdominal wall
and distended bladder following the use of a sterile needle and syringe
> This technique is used to obtain sterile urine for bacterial cultures from infants or adults, is aspirated into
the syringe, capped and sent for analysis

URINE SAMPLE COLLECTION
> The urine specimen containers for collection should be clean, dry, sterile, made of
clear translucent, disposable plastic or glass.
> It should be stable and able to stand upright, with a rim of 4-5 cm.
> It should be able to hold as much as 50-100 mL ofurine.
> It should also come with the lid tightly screwed on and should be a leakproof seal or
covered to prevent leaks or spills.
> Always wear gloves and proper PPE when working with urine.
Pediatric Collections:
> Sterile, plastic urine collection bags with a hypoallergenic skin adhesive are used for collection
after the perineal area is classed and dried prior to placement ofthe specimen bag onto the skin
> The patient is checked every 15 minutes to see if enough specimen has been collected

LABELLING
> Before the sample collection the container should be labelled immediately.
> Requiring patients to state their full name and birthdate, and to spell their first name and
lastname.
> It should be help avoid errors.
> The labels should contain adhesive that resists moisture and will stick during refrigeration.
> It should contain the
• Patient's full name
• A unique ID number
• The date and time of collection
• An ID or information about the room number or clinic name of
collection
• The type ofpreservative used and date/time.

Urine Storage and Handling :
> Ideally, once collected, urine specimens should be sent immediately to the laboratory.
> Time of arrival to the laboratory should be documented.
> If this is not possible, the specimen should be preserved or refrigerated.
> Transportation to the laboratory or some type ofpreservation must occur within 2 hours of
collection, otherwise the specimen will be no good and will need to be rejected.
> Urine is sensitive to light, temperature, moisture, and microbes in the environment.
Urine preservation method
> Urine preservative is basically either a chemical substance or a processor technique used to
prevent changes in the composition of the urine until it can be tested, or to prevent deterioration of
any formed elements.
> The most common form ofurine preservation is refrigeration, though there are chemical means to
preserve urine for a couple ofhours at room temperature as well.

> First morning urine specimens have high osmolality, and are therefore prone to salts crystallizing upon
cooling to room temperature, which are known as amorphous urates, which can interfere with some
cytological studies.
> Random urine specimens maybe preferred for this type of testing.
> Specimens need to be preserved within 2 hours of collection if not analyzed immediately.
> Changes in unpreserved urine maybe
A) Physical - Color, Clarity , Odour
B) Chemical - Ph, Glucose, Ketones, Bilirubin, Urobilinogen , Etc…..
C) Microscopic – Casts, Bacteria, Etc….
> The easiest and most common type ofpreservation is refrigeration of the urine specimen at 4-6 degrees
Celsius within 2 hours of collection if the specimen is not able to be tested right away.

> Timed urine collections may require the use of a chemical preservative.
• Boric acid
• Thymol
• Formalin
• Glacial acetic acid
• Sodium carbonate

STOOL SAMPLE COLLECTION
You will be collecting a sample for one or more tests, depending on your healthcare provider’sorder.
You may use the same bowel movement for more than one test. For each test:
> Unscrew the lid from the specimen container. Set aside.
> Prepare the collection container (clean shallow pan, plastic bag or clear plastic wrap) in which you
will collect your sample.
> Collect the sample. Do not collectstool that has been mixed with water or urine.
> Using the plastic spoon attached to the lid, scoop out samples from bloody, slimy or watery areas
of the stool (if present). If the stool is hard, select areas from each end and the middle of the stool.
> Transfer enough ofthe selected stool to the orange- and green-cap specimen containers to raise the
level of liquid to the “fill to here” line. Do not overfill.
> Screw the lid back on the container. Make sure it is closed tightly. Shake to mix.
> Place the specimen container in a zip-close bag and seal it.

Sample rejection criteria for clinical samples
> Improper test requests (incomplete, duplicate, errors in test input, inconsistent information)
> Inappropriate transport (transport temperature, light exposure, delayed transport time)
> Specimens without barcodes or unsuitable barcodes
> Misidentification (unlabeled, mislabeled or mismatched samples)
> Improper container or tube (including precious samples such as cerebrospinal fluid)
> Insufficient specimen volume (inappropriate blood/anticoagulant ratio)
> Incorrect preservation, storage
> Lipemic specimen
> Hemolyzed specimen
> Clotted samples with fibrin .

> Specimens which are improperly labeled.
> Specimens in which the quantity is not sufficient for proper processing.
> Specimens in which there has been a significant time delay between specimen collection and
specimen receipt (more than 24 hours), for which a transport tube/medium was not used and/or
specimen results would be compromised. Specimens and requisitions which are incompatible
(i.e. urine specimen with requisition checked off for sputum).
> Specimens received with no requisition.
> Liquid specimens which are not sent in sterile, dry, leakproof containers.
> Requisitions which have been contaminated with a liquid specimen.
> SPECIMENS IN SYRINGE WITH NEEDLE ATTACHED. Physician and/or office staff will be
contacted to remove needle before specimen will be processed.

clinicalpathologyppt-220319134410.pptx

clinicalpathologyppt-220319134410.pptx

More Related Content

Similar to clinicalpathologyppt-220319134410.pptx

More from LawalBelloDanchadi

Recently uploaded

clinicalpathologyppt-220319134410.pptx