How otn supercedes over sdh?

How otn supercedes over sdh?

• 1.
  How OTN supercedesover SDH/SONET Here we will discuss what are the advantages of OTN(Optical Transport Network) over SDH/SONET. The OTN architecture concept was developed by the ITU-T initially a decade ago, to build upon the Synchronous Digital Hierarchy (SDH) and Dense Wavelength-Division Multiplexing (DWDM) experience and provide bit rate efficiency, resiliency and management at high capacity. OTN therefore looks a lot like Synchronous Optical Networking (SONET) / SDH in structure, with less overhead and more management features. It is a common misconception that OTN is just SDH with a few insignificant changes. Although the multiplexing structure and terminology look the same, the changes in OTN have a great impact on its use in, for example, a multi-vendor, multi-domain environment. OTN was created to be a carrier technology, which is why emphasis was put on enhancing transparency, reach, scalability and monitoring of signals carried over large distances and through several administrative and vendor domains. The advantages of OTN compared to SDH are mainly related to the introduction of the following changes: Transparent Client Signals: In OTN the Optical Channel Payload Unit-k (OPUk) container is defined to include the entire SONET/SDH and Ethernet signal, including associated overhead bytes, which is why no modification of the overhead is required when transporting through OTN. This allows the end user to view exactly what was transmitted at the far end and decreases the complexity of troubleshooting as transport and client protocols aren’t the same technology. OTN uses asynchronous mapping and demapping of client signals, which is another reason why OTN is timing transparent. Better Forward Error Correction: OTN has increased the number of bytes reserved for Forward Error Correction (FEC), allowing a theoretical improvement of the Signal-to-Noise
• 2.
  Ratio (SNR) by6.2 dB. This improvement can be used to enhance the optical systems in the following areas:  Increase the reach of optical systems by increasing span length or increasing the number of spans.  Increase the number of channels in the optical systems, as the required power theoretical has been lowered 6.2 dB, thus also reducing the non- linear effects, which are dependent on the total power in the system.  The increased power budget can ease the introduction of transparent optical network elements, which can’t be introduced without a penalty. These elements include Optical Add-Drop Multiplexers (OADMs), Photonic Cross Connects (PXCs), splitters, etc., which are fundamental for the evolution from point-to-point optical networks to meshed ones.  The FEC part of OTN has been utilised on the line side of DWDM transponders for at least the last 5 years, allowing a significant increase in reach/capacity. Better scalability: The old transport technologies like SONET/SDH were created to carry voice circuits, which is why the granularity was very dense – down to 1.5 Mb/s. OTN is designed to carry a payload of greater bulk, which is why the granularity is coarser and the multiplexing structure less complicated. Tandem Connection Monitoring: The introduction of additional (six) Tandem Connection Monitoring (TCM) combined with the decoupling of transport and payload protocols allow a significant improvement in monitoring signals that are transported through several administrative domains, e.g. a meshed network topology where the signals are transported through several other operators before reaching the end users. In a multi-domain scenario – “a classic carrier’s carrier scenario”, where the originating domain can’t ensure performance or even monitor the signal when it passes to another domain – TCM introduces a performance monitoring layer between line and path monitoring allowing each involved network to be monitored, thus reducing the complexity of troubleshooting as performance data is accessible for each individual part of the route.
• 3.
  Also a majordrawback with regards to SDH is that a lot of capacity during packet transport is wasted in overhead and stuffing, which can also create delays in the transmission, leading to problems for the end application, especially if it is designed for asynchronous, bursty communications behavior. This over-complexity is probably one of the reasons why the evolution of SDH has stopped at STM 256 (40 Gbps). References: OTN and NG-OTN: Overview by GEANT