Engineering:Mode volume

From HandWiki
Short description: Number of bound modes that an optical fiber is capable of supporting


Mode volume may refer to figures of merit used either to characterise optical and microwave cavities or optical fibers.

In electromagnetic cavities

The mode volume (or modal volume) of an optical or microwave cavity is a measure of how concentrated the electromagnetic energy of a single cavity mode is in space, expressed as an effective volume in which most of the energy associated with an electromagentic mode is confined. Various expressions may be used to estimate this volume:[1][2]

  • The volume that would be occupied by the mode if its electromagnetic energy density was constant and equal to its maximum value

Vm=∫ϵ|E|2dVmax(ϵ|E|2)orVm=∫(|B|2/μ)dVmax(|B|2/μ)

  • The volume over which the electromagnetic energy density exceeds some threshold (e.g., half the maximum energy density)

Vm=∫(|E|2>|Emax|22)dV

  • The volume that would be occupied by the mode if its electromagnetic energy density was constant and equal to a weighted average value that emphasises higher energy densities.

Vm=(∫|E|2dV)2∫|E|4dVorVm=(∫|B|2dV)2∫|B|4dV

where E is the electric field strength, B is the magnetic flux density, ϵ is the electric permittivity, μ denotes the magnetic permeability, and max⁡(⋯) denotes the maximum value of its functional argument. In each definition the integral is over all space and may diverge in leaky cavities where the electromagnetic energy can radiate out to infinity and is thus not is not confined within the cavity volume.[3] In this case modifications to the expressions above may be required to give an effective mode volume.[4]

The mode volume of a cavity or resonator is of particular importance in cavity quantum electrodynamics[5] where it determines the magnitude[6][7][8] of the Purcell effect and coupling strength between cavity photons and atoms in the cavity.[9][10] In particular, the Purcell factor is given by

FP=34π2(λfreen)3QVm,

where λfree is the vacuum wavelength, n is the refractive index of the cavity material (so λfree/n is the wavelength inside the cavity), and Q and Vm are the cavity quality factor and mode volume, respectively.

In fiber optics

In fiber optics, mode volume is the number of bound modes that an optical fiber is capable of supporting.[11]

The mode volume M is approximately given by V22 and V22(gg+2), respectively for step-index and power-law index profile fibers, where g is the profile parameter, and V is the normalized frequency, which must be greater than 5 for this approximation to be valid.

See also

References

  1. ↑ "Calculating the modal volume of a cavity mode". https://optics.ansys.com/hc/en-us/articles/360034395374-Calculating-the-modal-volume-of-a-cavity-mode. 
  2. ↑ Kippenberg, Tobias Jan August (2004). Nonlinear Optics in Ultra-High-Q Whispering-Gallery Optical Microcavities (phd thesis). California Institute of Technology. doi:10.7907/t5b6-9r14.
  3. ↑ Meldrum, A. "Lesson 5: Whispering Gallery Modes". https://sites.ualberta.ca/~ameldrum/science/science5a.html. 
  4. ↑ Kristensen, P. T.; Van Vlack, C.; Hughes, S. (2012-05-15). "Generalized effective mode volume for leaky optical cavities" (in en). Optics Letters 37 (10): 1649. doi:10.1364/OL.37.001649. ISSN 0146-9592. https://opg.optica.org/ol/abstract.cfm?uri=ol-37-10-1649. 
  5. ↑ Kimble, H. J. (1998). "Strong Interactions of Single Atoms and Photons in Cavity QED" (in en). Physica Scripta T76 (1): 127. doi:10.1238/Physica.Topical.076a00127. ISSN 0031-8949. https://iopscience.iop.org/article/10.1238/Physica.Topical.076a00127. 
  6. ↑ Purcell, E. M. (1946-06-01). "Proceedings of the American Physical Society: B10. Spontaneous Emission Probabilities at Radio Frequencies" (in en). Physical Review 69 (11-12): 674–674. doi:10.1103/PhysRev.69.674.2. ISSN 0031-899X. https://link.aps.org/doi/10.1103/PhysRev.69.674.2. 
  7. ↑ Boroditsky, M.; Coccioli, R.; Yablonovitch, E.; Rahmat-Samii, Y.; Kim, K.W. (1998-12-01). "Smallest possible electromagnetic mode volume in a dielectric cavity" (in en). IEE Proceedings - Optoelectronics 145 (6): 391–397. doi:10.1049/ip-opt:19982468. ISSN 1350-2433. https://digital-library.theiet.org/content/journals/10.1049/ip-opt_19982468. 
  8. ↑ Chen, Tom. "Calculating cavity quality factor, effective mode volume, and Purcell factor in Tidy3D Flexcompute" (in en). https://www.flexcompute.com/tidy3d/examples/notebooks/CavityFOM/. 
  9. ↑ Srinivasan, Kartik; Borselli, Matthew; Painter, Oskar; Stintz, Andreas; Krishna, Sanjay (2006). "Cavity Q, mode volume, and lasing threshold in small diameter AlGaAs microdisks with embedded quantum dots" (in en). Optics Express 14 (3): 1094. doi:10.1364/OE.14.001094. ISSN 1094-4087. https://opg.optica.org/oe/viewmedia.cfm?uri=oe-14-3-1094&html=true. 
  10. ↑ Yoshie, T.; Scherer, A.; Hendrickson, J.; Khitrova, G.; Gibbs, H. M.; Rupper, G.; Ell, C.; Shchekin, O. B. et al.. "Vacuum Rabi splitting with a single quantum dot in a photonic crystal nanocavity" (in en). Nature 432 (7014): 200–203. doi:10.1038/nature03119. ISSN 0028-0836. https://www.nature.com/articles/nature03119. 
  11. ↑ Weik, Martin H. (2000), "mode volume" (in en), Computer Science and Communications Dictionary (Boston, MA: Springer US): pp. 1033–1033, doi:10.1007/1-4020-0613-6_11695, ISBN 978-0-7923-8425-0, https://link.springer.com/10.1007/1-4020-0613-6_11695, retrieved 2024-09-13 




Retrieved from "https://handwiki.org/wiki/index.php?title=Engineering:Mode_volume&oldid=3867283"